I the Washer Lid Bumper I ordered. It was kind of difficult to install. No matter how hard I pushed that bumper with my fingers it wouldn't go into the hole where it belongs on the washer. So finally I used the handle of a large screw driver screwdriver to push it in on one side but I couldn't push it in completely, so what I used next was a small small little screwdriver and I pushed the other side of the bumper bottom edge by pushing it in with the tip of the screwdriver, but not with a lot of force because I might damage the bumper by cutting it and that worked, I was able to get it in there completely. My washer is actually a Maytag and not a whirlpool since the part is for a Whirlpool washer.So maybe that's why it was difficult. I don't know all I know is the holes on my Maytag are on the corner of the opening of the washer and they are kind of slanted so it's hard to get full contact of the rubber to push it in with maybe a small mallet or something that won't damage the washer. So all in all I installed it, so now the lid closes softly with no more banging. I want to give thanks to Virginia service supply. I know I could have gotten the part here in my city since there is a Grainger company here that had the part and I could have just went and picked it up after I order it, but I like to help other companies out there.